Adjusting The Front Seats - Acura RLX 2019 Owner's Manual

Hide thumbs Also See for RLX 2019:
Table of Contents

Advertisement

VEHICLE CONTROLS
n
Intermittent (INT) Wipers
When you move the lever to the INT
position, the wipers operate based on
the delay adjustment.
Rotate the adjustment ring to adjust
the wiper delay.
*6
Automatic Rain-Sensing Wipers
n
When you move the lever to the AUTO position while driving in rainy
weather, the wipers operate based on the amount of detected rainfall.
Rotate the adjustment ring to adjust the rainfall sensor sensitivity. Set the
wipers to OFF when the rain stops.
Ensure the wiper lever is in the OFF position before entering a car wash or
cleaning the windshield. Wiper-system damage may happen otherwise.
Do not use the wipers when the windshield is dry. The windshield will get
scratched, or the rubber blades will get damaged.
In cold weather, the blades may freeze to the windshield, becoming stuck.
Operating the wipers in this condition may damage the wipers. Use the
defroster to warm the windshield, or manually clear the windshield of ice
and snow before turning on the wipers.
36 |
*6 - With automatic intermittent wipers

Adjusting the Front Seats

Adjust the driver's seat as far back as
possible while allowing you to maintain
full control of the vehicle. You should be
able to sit upright and well back in the
seat, adequately press the pedals
without leaning forward, and grip the
steering wheel comfortably. The
passenger's seat should be adjusted so
that it is as far back from the front airbag
in the dashboard as possible.
The National Highway Traffic Safety
Administration recommends that drivers
allow at least 10 inches (25 cm) between the center of the steering wheel and
the chest.
VEHICLE CONTROLS
| 37

Advertisement

Table of Contents
loading

Table of Contents