Changing The Light Bulb - CDA FW422 Installation, Use And Maintenance Manual

Changing the light bulb

If your fridge has a halogen bulb:
• Disconnect the appliance from the power.
• Carefully remove the light cover by pushing in the lever at the back
of the cover, and then pulling the cover down.
• Unscrew the old light bulb to remove it and replace with a new bulb
(not more than 15W). Be careful as the bulb may be hot. Always wear
adequate protection for your hands. Please note that you can fit a
15W LED bulb if you prefer.
• Replace the light cover and reconnect the power after five minutes'
delay as explained on page 3.
If your fridge has LED lighting:
• Disconnect the appliance from the power.
• Carefully remove the screw from the light cover. Then, remove the
cover by simply pulling it firmly away from the housing. Do not worry
if the housing moves slightly - reinserting the screw later will remedy
this.
• Unscrew the old light bulb to remove it and replace with a new LED
bulb (not more than 15W). Be careful as the bulb may be hot. Always
wear adequate protection for your hands.
• Replace the cover by replacing the cover lip nearest the thermostat
dial first and then slot the remaining lips in. Reinsert the screw and
tighten. Reconnect the power after five minutes' delay as explained
on page 3.
10