Connection Log Messages - Siemens SpeedStream SS2624 User Manual

Buttons
Connect
Disconnect
Clear Log
Refresh

Connection Log Messages

Message
Connect on Demand
Manual connection
Reset physical connection
Connecting to remote
server
Remote Server located
Start PPP
PPP up successfully
Idle time-out reached
Disconnecting
Error: Remote Server not
found
Error: PPP Connection
failed
Error: Connection to
Server lost
Error: Invalid or unknown
packet type
The "Clear Log" button will restart the Log, while the Re-
fresh button will update the messages shown on screen.
If not connected, establish a connection to your ISP.
If connected to your ISP, hang up the connection.
Delete all data currently in the Log. This will make it easier to
read new messages.
Update the data on screen.
Description
Connection attempt has been triggered by the "Connect auto-
matically, as required" setting.
Connection attempt started by the "Connect" button.
Preparing line for connection attempt.
Attempting to connect to the ISP's server.
ISP's Server has responded to connection attempt.
Attempting to login to ISP's Server and establish a PPP con-
nection.
Able to login to ISP's Server and establish a PPP connection.
The connection has been idle for the time period specified in
the "Idle Time-out" field. The connection will now be termi-
nated.
The current connection is being terminated, due to either the
"Idle Time-out" above, or "Disconnect" button being clicked.
ISP's Server did not respond. This could be a Server problem,
or a problem with the link to the Server.
Unable to establish a PPP connection with the ISP's Server.
This could be a login problem (name or password) or a Server
problem.
The existing connection has been lost. This could be caused by
a power failure, a link failure, or Server failure.
The data received from the ISP's Server could not be proc-
essed. This could be caused by data corruption (from a bad
link), or the Server using a protocol which is not supported by
this device.
Operation and Status
47