Setting Up The Sony Amplifier - Sony NAC-SV10i Operating Instructions Manual

To select the uppercase or
lowercase letters
Press a/A to switch between lowercase ("abc") and
uppercase ("ABC") letters.
To enter punctuation marks (e.g.,
!, ?, etc.) or symbols (e.g., #, %,
etc.)
Press 1 or 0 of the numeric/text button repeatedly
while the type of characters is set to "abc" or
"ABC."
To enter a space
Press 0 of the numeric/text button repeatedly while
the type of characters is set to "abc" or "ABC."
To delete a character
Press CLEAR.
Characters that are assigned to
each numeric/text button
The table below shows the characters and numbers
that you can enter for each type ("abc," "ABC," or
"123"). You can check the characters, numbers
and symbols that are assigned to each numeric text
button.
Numeric/ abc
text
button
1 . , ! @ ´ ` : ; ( )
[ ] { } < > 1
2 a b c 2
3 d e f 3
4 g h i 4
5 j k l 5
6 m n o 6
7 p q r s 7
8 t u v 8
9 w x y z 9
0 / \ | - ~ = _ + #
$ % & ^ " * ?
(space) 0
ABC 123
. , ! @ ´ ` : ; ( ) 1
[ ] { } < > 1
A B C 2 2
D E F 3 3
G H I 4 4
J K L 5 5
M N O 6 6
P Q R S 7 7
T U V 8 8
W X Y Z 9 9
/ \ | - ~ = _ + # 0
$ % & ^ " * ?
(space) 0
Setting up the Sony
amplifier
You can use the remote control to control the Sony
amplifier (power on/off and volume).
Numeric
buttons (1-4)
Press the corresponding numeric
button (1 to 4) while pressing AMP ?/1
to select the Sony amplifier.
Press Type of amplifier
AMP ?/1 and 1
Sony stereo amplifier or
receiver
AMP ?/1 and 2 Sony Mini/Micro system
AMP ?/1 and 3
Sony AV receiver, multi
channel amplifier, or home
theater system
AMP ?/1 and 4 Sony home theater system
( : Factory setting)
Note
It is possible to change the remote control code to make
the remote control compatible with a multi channel
amplifier or home theater system. If you do not know
what your Sony amplifier type is, try selecting each of the
four codes above to find out which one corresponds with
your amplifier. This remote control may not be
compatible with some Sony products.
AMP ?/1
AMP VOL +/–
19 GB