Messages - Sony NAC-SV10i Operating Instructions Manual

The sound skips.
,
The bandwidth of your wireless LAN may be too
low. Move the unit and the wireless LAN router/
access point closer to each other, without any
obstacles between them.
The elapsed time is not displayed on the
playback display.
,
The elapsed time may not be displayed depending on
the content.
Play Timer
"Date&Time Error" appears.
,
If the clock on the unit has not been set, you cannot
set the Play Timer. Set the clock before setting the
Play Timer (page 22).
"Time Error" appears.
,
The ending time for the Play Timer cannot be the
same as the starting time.
Play Timer setting does not function when the
starting time is reached.
,
A power failure occurred while the timer setting was
in standby mode or the AC power adaptor was
disconnected.
Others
The unit works poorly.
,
The unit may be under the influence of static
electricity or other factors. In this case, restart the
unit. If the unit still works poorly, reset the unit
(page 61).
,
If a warning message appears, follow the instructions
given by the message.
The unit does not respond to any operations.
The unit does not work correctly.
,
The unit's internal system may be malfunctioning, or
the unit may be suffering from strong electrical noise
caused by power supply abnormalities due to being
dropped, excessive static electricity, or lightning. In
this case, disconnect the AC power adaptor from the
wall outlet, wait about 40 seconds, and then
reconnect it.

Messages

Common messages
Browse Limit
You tried to select the 11th level in a file tree while
the unit can select down only to the 10th level.
Cannot connect.
[ Network settings ]
The unit cannot connect to a network, or the unit
cannot obtain the IP address because it cannot
connect to the DHCP server for some reason (e.g.,
you input an incorrect WEP key). Check the
network connection (page 31) or go to the network
settings procedures and input the security key
(WEP Key, WPA/WPA2 Key) again (page 24).
[ Clock setting (Date&Time Settings) ]
The unit cannot connect to the NTP server. Check
that the NTP server address is correct.
Cannot connect to server.
The unit cannot connect to the server because the
server may be turned off or the server may not be
connected to a network. Turn on the power of the
server or check if the server is connected to a
network correctly.
Cannot Play
You tried to play audio content that the unit cannot
play.
Cannot Retrieve Info
The unit cannot retrieve information from the
server.
The unit failed to obtain the registration code for
the Music Services settings. Check the registration
code again (page 43).
Data Error
The selected audio content (data) has been
damaged.
No Content
There is no content in the selected folder on the
server.
No Results
There is no item that corresponds to the keyword
used to search for that item.
Not Available
The operation that you performed is unavailable or
invalid.
65 GB