Wan/Cellular - Sierra Wireless AIRLINK HELIX 2140847 User Manual

AirLink Helix User Guide
Table 5-1: Status: Home
Command
Backhaul mode
Phone Number
Current WAN IP
address
Network State
RSSI
Network Operator
Network Service Type
ALEOS Software
Version
Channel
Modem Name
Command
Cellular IP Address
Ethernet IP Address
WAN Link
ESN/EID/IMEA
20
Description
WAN backhaul mode : cellular, failover, passthrough.
This is the phone number that is programmed in to your device.
This can be the IP address of the cellular modem, if it is being used or the IP address of
WAN port if WAN Failover has switched to the Ethernet connection.
Not Connected or Connected. Current state of the cellular radio.
Signal strength of the cellular signal. The lower the number, the better the signal strength.
The exact numbers vary between cellular carriers. However, -40dBm means Helix has a
significantly stronger coverage area than when it is -70dBm.
Indicates the network the modem is currently on.
The type of service being used by the modem, for example EV-DO Rev A or HSPA.
Software version of the ALEOS build.
The current active CDMA/GSM channel number.
Name of the modem.

WAN/Cellular

WAN/cellular status indicates specific information about the cellular connection
including IP address and how much data has been used.
Figure 5-2: ACEmanager: Status - WAN/Cellular
Description
Cellular WAN IP Address.
Ethernet IP Address. This is present in WAN failover mode only.
WAN Link defaults to cellular. In WAN failover mode this can be either cellular or Ethernet.
The cellular radio module's unique identification number or electronic serial number (ESN
or IMEA).
2140847