Celestron SkyScout Scope 90 Quick Setup Manual

1
Your SkyScout Scope 90 includes: optical tube w/
attached SkyScout mounting bracket, pre-assembled
tripod with center leg brace and altazimuth mount
attached; two eyepieces; erect image diagonal,
finderscope and bracket, accessory tray, owner's
manual, and The Sky™ CD Software. SkyScout not
included.
4
All three legs should be the same length to provide a
level platform for the telescope.
7
Here is how the fully assembled tripod and mount
should appear.
Quick set-up guide for:
Model #21068 – SkyScout Scope 90
2
To set up the tripod, spread the legs outward until
they are fully extended. Extend each of the three
tripod legs as far as they will go.
5
To attach the accessory tray, line up the three tabs
and turn clockwise until tray tabs lock into place with
the tripod's center leg brace.
8
Dovetail
Mount
Fastening
screws
Next slide telescope tube into the mount. Be sure to
back out fastening screws to allow enough clearance
for the dovetail.
www.celestron.com
Questions or Problems with Set-up?
CONTACT: Celestron Technical Support:
310.803.5955
Quick Set-up Guide
3
Use the three tightening screws located at the bottom
of each leg to secure the extended legs
in place.
6
Properly assembled, the accessory tray should appear
as pictured above.
9
Center dovetail in the mount and tighten fastening
screw. For added security tighten the angled lock
down screw next to the fastening screw.