1. Align and place the touchpad into the slot on the palm-rest and keyboard assembly.
2. Replace the two (M1.6x2) screws that secure the touchpad to the palm-rest and keyboard assembly.
3. Slide the touchpad cable onto its connector on the system board and close the latch to secure the cable.
4. Align and place the touchpad bracket into the slot on the palm-rest and keyboard assembly.
5. Replace the three (M2x3) screws that secure the touchpad bracket to the palm-rest and keyboard assembly.
1. Install the speakers.
2. Install the battery.
3. Install the
base
cover.
4. Follow the procedure in
Display assembly
Removing the display assembly
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
WLAN
card.
After working inside your
computer.
Before working inside your
computer.
Removing and installing components
45