BBV RX100 Installation Manual page 36

BBV Rx100
Addendum to manual for the following camera:
Application Notes
The RX 100 provides control of Zoom and Focus and Menu Access.
Advanced Features Tx400 Tx1000
Display MENU '#' 1
The camera and Rx100 are linked using RS485 for control and video for the camera signal.
Rx100 Description
J3-C1 TX-/B
J3-C2 TX+/A
Notes:
Before controlling from the RX100 please enter the camera menu using the MENU button and set the following:
CAMERA ID – 001
PROTOCOL – P/D
The alarm output relay opens for approx 5 seconds upon power up and following any active alarm input.
To allow easy navigation in the camera menu the pan and tilt functions generate zoom and focus commands even when not
displaying the camera menu. This is NOT a fault!
To aid with confirming correction connection and operation fitting the TEST link to make the camera ZOOM IN and remove
to make the camera ZOOM OUT. If this is fine then the RX100 and camera are communicating correctly.
The camera manual has detailed information on the menu structure and privacy setting.
Rx100 installation manual V1.17 29 Aug 08.doc
Interface Receiver
Videcon VCP451 Camera
Rx100 software RX1_V5V1
Tx1500
'#' WASH 1 '#'
Camera connection
RS485-
RS485+
(The Rx100 uses PELCO D, 2400,N,8,1 to drive this camera)
DM DS/DS2/BX2 Mux
*889 002 or *889 10 10 2
Page 36