BBV RX100 Installation Manual page 31

Rx 100
Interface Receiver
Application Notes
The RX 100 provide the following functionality when controlling the above mentioned domes
Variable speed Pan/Tilt, from 0.8deg/sec to 120deg/sec.
Zoom/Focus, Autofocus following a Zoom In/Out.
(Autofocus enabled with link fitted on J6 pin 1&2)
16 Full scene presets.
2 preset patrols.
4 alarm inputs.
Additional commands:
AUTOPAN: Pressing the AUTOPAN key will run the domes in-built swing feature. Preset positions 1 & 8 must be
programmed before the swing is started. Preset 1 is the right hand stop, preset 8 is the left hand stop. Tilt and lens can be
adjusted whilst the dome is swinging.
180deg PAN AUTO FLIP is accomplished by pressing either '#'WASH on Tx1000 or '#'1 on Tx400.
DOME REMOTE RESET can be started by pressing either '#'LIGHTS on Tx1000 or '#'4 on Tx400.
RS485 control of dome using the following connections:
Rx100 Description
J3-C1 TX/RX- Data-
J3-C2 TX/RX+ Data+
Notes:
The alarm output relay opens for approx 2 seconds upon power up. This can be used to signal power loss, etc.
When programming a preset position, control is prohibited until the dome has stored the position into it's eeprom memory, approx 1-2 seconds.
Following a goto preset command, all further commands are ignored until the dome has reached it's preset position including any alarm input.
If swing is running, start patrol 1 & 2 is inhibited. The dome will be driven to a preset following an alarm activation. 60 seconds after alarm, swing will restart.
If a manual goto preset is pressed, the dome will stop swinging and move to the preset position. The AUTOPAN led will be on until the next manual pan
command.
Rx100 installation manual V1.17 29 Aug 08.doc
Addendum to manual for the following domes:
Chugai SMD-08II, SMD-12, SMD-12II, SMD-20
Sanyo VCC-9200P
Star MD-800, MD-1200S, MD-1200H, MD-2000
Rx100 software RX1_S2V6
Dome mounting bracket
Pin 2
Pin 1
Page 31