BBV RX100 Installation Manual page 30

BBV Rx 100
Addendum to manual for the following camera:
Application Notes
Variable speed Pan/Tilt.
Zoom/Focus, Autofocus with manual override (returns to auto following zoom command)
6 full scene presets
2 preset patrols
4 alarm inputs driving to preset 1 – 4
Advanced Features
Toggle Backlight compensation
Cycle White Balance
AUTO, INDOOR, OUTDOOR
Toggle AutoExposure/Bright mode
Iris keys used in Bright mode
Reset dome to default
RS232 control of dome 9600 Baud, No parity, 8 data bits, 1 stop bit. The camera uses a sub-miniature 8 pin DIN socket. A
Sony supplied VISCA to DB9 RS232 cable may help with installation.
Connection details:
Camera Pin Description
5 Receive Data
4 or 6 Ground
Notes:
Link J6/1-2 selects a 5 minute datum mode. If fitted and no activity for 5 minutes, the camera will drive to either preset 1 or start PATROL 1 depending on link
J6/3,4,5, Fitted to J6/4&5 = Goto Preset 1 or fitted to J6/3&4 = start PATROL 1.
The alarm output relay opens for approx 5 seconds upon power up. This can be used to signal power loss, etc.
Check with the multiplexer manual for exact procedure for entering * commands.
IMPORTANT:
Ensure that CAMERA NO switch on the camera rear panel is set to 1.
As communications is RS232 please limit cable from Rx100 to camera to less than 5M.
Rx100 installation manual V1.17 29 Aug 08.doc
Interface Receiver
Sony EVI-D31 Webcam
Rx100 software RXS4V3
Coaxial telemetry ONLY. Not twisted pair.
Tx400 Tx1000
'#' '1' '#' WASH
'#' '2' '#' WIPE
'#' '3' '#' AUTOPAN 3 '#'
'#' '4' '#' LIGHTS
Rx100
J3/C1
J3/GND
Tx1500 DM Sprite/DS2/BX2
1 '#' *889 002 or 10 10 2
2 '#' *889 003 or 10 10 3
*889 004 or 10 10 4
4 '#' *889 005 or 10 10 5
Page 30