Table of Contents
Advertisement
4. INSTALLATION
This chapter describes the procedure of the installation. The following topics are covered:
l
Overview
l
Utility Diskette
l
Write Protect Function
l
Watchdog Timer
4.1 OVERVIEW
This chapter provides information for you to set up a working system based on the AR-B1474 CPU card. Please
read the details of the CPU card' s hardware descriptions before installation carefully, especially jumpers setting,
switch setting and cable connection.
Follow steps listed below for proper installation:
Step 1 :
Read the CPU card' s hardware description in this manual.
Step 2 :
Install any DRAM SIMM onto the CPU card.
Step 3:
Install the EPROMs, FLASHs ro SRAMs on the memory sockets.
Step 4 :
Set jumpers and switch.
Step 5 :
Make sure that the power supply connected to your passive CPU board is turned off.
Step 6 :
Plug the CPU card into a free AT-bus slot or PICMG slot on the backplane and secure it in place with
a screw to the system chassis.
Step 7 :
Connect all necessary cables.
connected to pin 1 of the related connector.
Step 8 :
Connect the hard disk/floppy disk flat cables from the CPU board to the drives. Connect a power
source to each drive.
Step 9 :
Install a MDA, CGA, EGA or VGA display card in your system.
Step 10 : Plug the keyboard into the keyboard connector.
Step 11 : Turn on the power.
Step 12:
Configure your system with the BIOS Setup program then re-boot your system.
Step 13: If the CPU card does not work, turn off the power and read the hardware description carefully again.
Step 14: If the CPU card still does not perform properly, return the card to your dealer for immediate service.
Make sure that the FDC, HDC, serial and parallel cables are
AR-B1474 User¡ ¦ s Guide
4-1
Advertisement
Table of Contents
