Installation; Input Cable Connection - WilTec TIG180 Operation Manual
Hide thumbs
Also See for TIG180:
- Operation manual (11 pages) ,
- Operation manual (13 pages) ,
- Operation manual (13 pages)
Table of Contents
Advertisement
EXPLANATION SWITCH
INSTALLATION
When you want to use a longer cable, please choose a cable of bigger section in order to protect volt-
age from stepping down. If torch cable is too long, it maybe affects the function of arc-striking and
other functions of system. Due to this we suggest that the user must the length which is recommended
by manufacturer.
INPUT CABLE CONNECTION
Every welding machine has disposed a power cable which must be connected to corresponding volt-
age in compliance with input voltage. If a single phase 230v DC power cable is connected to 380v AC
power cable by carelessness, it will make the power switch into over-voltage protection position.
Please turn power supply off first and then connect the machine to power of 220v and open it again.
Input voltage must be single phase 230V.
Make sure that power cable is connected to power switch or connector firmly and prevent from oxidiz-
ing. Check if the power voltage is inside waved range.
© by WilTec Wildanger Technik GmbH
Seite 16
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Advertisement
Table of Contents
