Output Cable Connection - WilTec TIG180 Operation Manual

OUTPUT CABLE CONNECTION

When using argon-arc welders, please connect them as aforementioned. When you use striking, pay
attention as following:
Every machine has a pair of mobile plugs. The cable of welding handle has to be connected to the
black mobile plug, the other terminal of grounding pincer has to be connected to the red mobile plug.
After that they must be tightened. Make sure secondary cables (handle cable and grounding cable)
are connected to the mobile plug reliably.
Insert the mobile plug into the mobile socket and then tighten it. Otherwise the plug and socket will be
burned up if the current is too high or working time is too long.
Pay attention to the electrode of connection cable. There are two methods of connection: positive con-
nection and negative connection. Positive connection is when thework piece is connected to positive
electricity and torch handle is connected to a negative electrode; negative connection is when the work
piece is connected to negative electricity and the torch handle is connected to a positive electrode.
INSTALLATION PICTURE
© by WilTec Wildanger Technik GmbH Seite 17
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de