Replace Drive Belt - Bissell PowerForce 3522 User Manual

Check Rotating Floor Brush and Drive Belt Continued
Clean strings, hair and other debris from Rotating Floor Brush,
5.
paying particular attention to brush ends.
Clean strings, hair and other debris from Motor Pulley and Drive
6.
Belt areas.
Check Drive Belt carefully for wear, cuts or stressed areas.
7.
Replace if worn.
Check Air Passageway for obstructions. Remove debris from
8.
this area.

Replace Drive Belt

Use only BISSELL Style 7 Replacement Belts (#32074) in your
BISSELL PowerForce.
Unplug cleaner from electrical outlet.
1.
With Rotating Floor Brush removed from vacuum cleaner
2.
(Steps 1-4 of Check Rotating Floor Brush and Drive Belt),
grasp old Drive Belt and remove from Motor Pulley. Discard
old Drive Belt.
Place new Drive Belt over Motor Pulley and stretch other end
3.
over Rotating Floor Brush in the space between the bristles.
Place ends of Rotating Floor Brush down into slots on sides
4.
as shown.
Turn Rotating Floor Brush by hand several times in direction of
5.
Motor Pulley. If properly installed, Drive Belt will center itself.
Reposition Brush Cover and four screws. Tighten screws
6.
securely. Make sure end of Brush Cover is snapped into place.
Replace Light Bulb
(Select Models)
Use only BISSELL Replacement Bulbs in your BISSELL
PowerForce.
Unplug cleaner from electrical outlet.
1.
Using a Phillips head screwdriver, remove the two screws as shown
2.
and lift off the lens.
Determine the light bulb type of your vacuum:
3.
Standard Bulb (#203-1297) – approximately 1" long, flat end.
Large Bulb (#203-1007) – approximately 2" long, round end.
Standard Bulb – remove the bulb from the socket by grasping
4.
bulb and pulling straight out. Install the new bulb by pushing
it gently into the socket until the bulb snaps into place
Large Bulb – remove the bulb from the socket by pushing in
gently and turning it towards brush. Install the new bulb by
pushing it gently into the socket and turning away from the brush.
Reposition lens and secure with the two screws.
5.
Motor
Pulley
Air Passageway
Press here
Large Bulb
Small Bulb
Brush
Cover
9