Replace Dust Bag; Cleaning Pre-Motor & Post-Motor Filter; Check Rotating Floor Brush, Drive Belt - Bissell PowerForce 3522 User Manual

Replace Dust Bag

Never reuse a Dust Bag.
Use only BISSELL Style 7 Dust Bags in your BISSELL PowerForce.
Style 7 EnviroFresh
Style 7 Dust Bags (# 32120).
Unplug cleaner from electrical outlet.
1.
Pull the Bag Door outward to open. Set Bag Door aside.
2.
Grasp Dust Bag Collar, and pull Collar from Connector
3.
Tube. Discard used Dust Bag.
Grasp new Dust Bag Collar and push firmly onto
4.
Connector Tube. Tuck in Dust Bag.
Replace Bag Door by placing tab on bottom of door into
5.
opening as shown. Press top of door to snap securely shut.
NOTE: Vacuum will not suction while the Bag
Door is removed.
Cleaning Pre-Motor & Post-Motor Filter
Use only BISSELL Replacement Filters in your BISSELL
PowerForce. Filter Kit (#203-1089)
Unplug cleaner from electrical outlet.
1.
The Pre-Motor Filter, located in the bottom of the bag
2.
compartment, protects the motor from dirt particles. If filter
becomes dirty, lift out filter and clean.
The Post-Motor Filter assists in the filtration process to return
3.
clean air to the room. To remove this filter, open the door on the
side of the cleaner. Grasp filter and pull it straight out.
The filters may be hand washed in cold water with mild
4.
detergent, then air dried.
Reposition filters when completely dry.
5.
Check Rotating Floor Brush and Drive Belt
You should check your vacuum cleaner's Rotating Floor Brush
and Drive Belt regularly for wear or damage. You should also
clean the brush and brush ends of string, hair, and carpet fibers.
These can wrap around the brush and hamper its ability to
effectively clean your carpet. Also remove any debris that has
accumulated under the brush cover.
Unplug cleaner from electrical outlet.
1.
Place handle in Low position and turn vacuum cleaner over so
2.
bottom side is up.
Remove the four screws as shown with a Phillips head
3.
screwdriver. Lift the Brush Cover off.
Grasp Rotating Floor Brush at both ends and lift.
4.
8
®
Micro Filtration Dust Bags (# 30861)
Post-Motor
Pre-Motor
Filter
Filter
WARNING:
Do not operate cleaner
with damp or wet filters or
without all filters in place.
WARNING:
To reduce the risk of
injury from moving parts,
turn off vacuum cleaner
and disconnect Power
Plug from electrical outlet.
Brush
Cover