Introduction - Siemens MK8000 Quick Reference Manual

2

Introduction

# Step
1 MM8000 Management Station is sold.
2 Customer chooses a 3
3 MK8000 project is assigned to a project manager (PM)
Technical requirements defined during the sales process are given to
the technical team that the PM oversees.
4 PM defines the exact needs of the customer.
Before planning commissioning, the project manager meets with the
customer to understand any special needs he may have.
PM ensures that all "variables" necessary for installation and
5
commissioning are present.
"Variables" are items such as power supplies, network outlets, instal-
lation areas, and connection wires to fire panels. These items should
have been specified in the contract, and provided by the 3rd party
suppliers or the customer. If there is a problem in this phase, the
project plan is revised.
Note: The order of steps 6, 7, and 8 may vary.
6 DU provides information to the 3rd party integration group
about
the MK8000 data model and interfaces
rd
The 3 party client integration will be working in parallel with the DU
through the installation, configuration and commissioning phases,
while they configure the client for integration with the MK8000. Dur-
ing this phase, the DU may need to provide information and guidance
to the integration group with areas, such as the importance of certain
"tags".
7 Hardware is installed at the client site
8 MK8000 project is configured in Composer
Building Technologies
Fire Safety & Security Products
This is a guide to the software installation, configuration and commissioning of the
MK8000 OPC Server.
From point-of-sale to project handover
The following is an overview of the phases or steps that occur from the point-of-
sale to project handover to the customer. Documentation that supports a given
step is shown on the right-hand column; see Reference Documents at p.7.
Note: The steps relevant to this document are in black, while the other steps are
shown in grey.
The following is an overview of the phases or steps that occur from the point-of-
sale to project handover to the customer. Documentation that supports a given
step is shown on the right-hand column; see Reference Documents at p.7.
Note: The steps relevant to this document are in black, while the other steps are
shown in grey.
rd
party OPC Client and integration group.
Documents
[Sales Material]
[Contract]
[Interface specifications]
Configuration, p 35
[DMS8000 connectivity configuration
guide]
[Composer Technical Manual]
048_DMS_MK8000_ICC_MP4.10_A6V10062407_a_en.doc
Introduction
13
06.2007