Putting The Machine Down - Siemens SIMOTICS FD 1MM1 Series Operating And Installation Instructions

Note
Place the machine in a secure and raised position
In order to obtain easy and safe access to the underside of the machine, place it in a secure and
raised position.
Standing under suspended loads
If the lifting gear or load handling attachments were to fail, the machine could fall. This can
result in death, serious injury or material damage.
● Never remain under or in the immediate vicinity of the machine when it is raised.
5.3.8

Putting the machine down

Requirements
The following preconditions must be satisfied before setting down the machine at the
installation location:
● The mating faces must be clean.
● The anti-corrosion protection paint has been removed from the mating faces, such as the
●
Setting down the machine
● Set down the machine slowly and carefully at the installation location to avoid any impact.
See also
Draining condensation (Page 62)
SIMOTICS FD 1MM1
Operating Instructions 02/2019
DANGER
machine mounting feet, flange, ...
There is no condensation present within the machine.
5.3 Lift the machine to where it will be installed, and position it
Assembly
61