Crown DLTM-40 Installation & Operation Manual page 9

INSTALLATION AND OPERATION MANUAL, DIRECT STEAM SINGLE & TWIN MIXER
KETTLE, MODELS DLTM-40 TO DLTM-100 AND DLTM-40-2 TO DLTM-100-2
5.0 OPERATING INSTRUCTIONS (Continued)
NOTE: Mixer agitator arms must be stopped at 90 degrees to the
mixer bridge before raising the bridge. If the agitator arms do not
stop in this position when speed selector is set to stop, then "jog"
the selector on and off to achieve this position.
Push and hold the "TILT" switch in the "RAISE" position. Bridge will raise to maximum height.
Bridge will stop at any position if the tilt switch is released and will remain in that position until
switch is pushed to either raise or lower. When the bridge is fully raised it can be manually
turned to the side to clear kettle.
NOTE: The bridge is equipped with a safety switch which prevents turning of
the agitators, regardless of the mixer switch, or speed control settings.
Agitators will not engage unless the bridge is lowered so that the guide pin
rests fully in the guide pin bracket on the side of the kettle.
REMOVAL OF AGITATORS
For ease of cleaning, the agitators are removable without tools. To remove, raise bridge as
described above and swing clear of kettle. Grasp shaft of large agitator, push up and turn to
disengage lock pin. Pull straight down on agitator. Remove the small agitator in the same
manner. Soak and wash agitators in warm, soapy water. Never use abrasive cleansers or
scouring pads on the stainless steel surfaces as this will damage the finish of the stainless
steel.
If it is necessary to remove the scraper blades from the large agitator for cleaning purposes, do
so by removing the pin at the end of the mounting shaft and then slide the scraper blades off of
the shaft.
To clean the exterior stainless steel panels of your unit, use a damp soft cloth or soft cloth and
stainless steel cleaner. Never use abrasive cleansers or scouring pads on the stainless steel
surfaces as this will damage the finish of the stainless steel.
Part No. 10040R4 9 2018-12-05