Before Calling for Service....14 Commercial Microwave Oven Keep these instructions for future reference. If the oven changes ownership, be sure this manual accompanies the oven. Part No. 20152601 2014 ACP, Inc. Printed in U.S.A. 03/14 Cedar Rapids, Iowa 52404 Original Instructions...
Model Identification When contacting ACP, provide product information. Any questions or to locate an authorized ACP Product information is located on oven serial plate. servicer, call toll free 1-866-426-2621 inside U.S.A. or Record the following information: Canada, or 1-319-368-8120 outside U.S.A or Canada.
, turn oven off and disconnect the power cord, or shut off power at the circuit breaker panel. SAVE THESE INSTRUCTIONS 2014 ACP, Inc. Part No. 20152601 Cedar Rapids, Iowa 52404 Printed in U.S.A. 03/14 Original Instructions...
Page 4
Record all inspections and and may cause an electrical arc, malfunction, or repairs for future use. damage to oven. SAVE THESE INSTRUCTIONS Part No. 20152601 2014 ACP, Inc. Printed in U.S.A. 03/14 Cedar Rapids, Iowa 52404 Original Instructions...
Located on outside of oven back, terminal is marked with symbol shown below. Part No. 20152601 2014 ACP, Inc. Printed in U.S.A. 03/14 Cedar Rapids, Iowa 52404 Original Instructions...
Stage: 1 Manual Stage: 1 shows during cook cycle 00:50 MW: 100% 01:23 MW: 50% Cooking time User specified percentage of microwave power Part No. 20152601 2014 ACP, Inc. Printed in U.S.A. 03/14 Cedar Rapids, Iowa 52404 Original Instructions...
Page 7
Programming Oven Controls section of this manual. feature, see pages 11 and 12 of the Programming Oven Controls section of this manual. Part No. 20152601 2014 ACP, Inc. Printed in U.S.A. 03/14 Cedar Rapids, Iowa 52404 Original Instructions...
Page 8
To change section of this manual. different options, see page 11 of the Programming Oven Controls in this manual. Part No. 20152601 2014 ACP, Inc. Printed in U.S.A. 03/14 Cedar Rapids, Iowa 52404 Original Instructions...
Run the microwave for one minute. If the tested container is warm or hot, it is not microwave safe. Part No. 20152601 2014 ACP, Inc. Printed in U.S.A. 03/14 Cedar Rapids, Iowa 52404 Original Instructions...
7. Press PROGRAM SAVE to save the programming and changes. 8. To discard changes, press STOP/RESET before pressing 00:50 MW: 100% PROGRAM SAVE. Flashing Part No. 20152601 2014 ACP, Inc. Printed in U.S.A. 03/14 Cedar Rapids, Iowa 52404 Original Instructions...
• To change additional options repeat steps 3 and 4 Press PROGRAM SAVE to return to READY mode, changes take effect immediately. To exit without saving, press the STOP pad. Part No. 20152601 2014 ACP, Inc. Printed in U.S.A. 03/14 Cedar Rapids, Iowa 52404 Original Instructions...
Oven will display CLEAN FILTER every 30 days Quarterly Oven will display CLEAN FILTER every 90 days Options in bold are factory default. 2014 ACP, Inc. Part No. 20152601 Cedar Rapids, Iowa 52404 Printed in U.S.A. 03/14 Original Instructions...
To avoid risk of product damage, do not operate oven without splatter shield in place. Arcing will damage oven cavity and antennas when operated without shield in place. 2014 ACP, Inc. Part No. 20152601 Cedar Rapids, Iowa 52404 Printed in U.S.A. 03/14 Original Instructions...
Place one cup of water in oven. Run for one (1) minute at full power (100%) If temperature does not rise, oven is not operating correctly. Contact ComServ at 1-866-426-2621 or an authorized ACP servicer. HOT displays Oven’s magnetron is overheated. Oven automatically interrupts cooking sequence and turns on cooling fan until normal temper- ature is reached.