ACP MSOx Quick Start & Reference Manual

Stage
1
User can program up to four different
2
3
stages per keypad to combine power levels
4
and time changes.
A/B Pad
A/B
Toggles selection between two sets of
preprogrammed menu settings.

Power Level

Changes microwave power level for
different stages of a cook cycle.
0
Quantity
X2
Automatically adjusts preprogrammed cook
cycle for cooking two of the same food
item.
Program Save
Programs or settings can be changed and
saved based on a user's preference.
Time Entry
Cooking time can be changed for either
manual entry or programming.
USB Compatibility
A standard USB flash drive is compatible with
the microwave oven, allowing the user to save
preprogrammed settings to the flash drive rather than the
oven.
1. Oven must be in READY mode. If not, open and close the
door.
2. Open the oven door completely.
3. Insert USB flash drive.
4. Press and hold the 5 keypad until "USB" appears on the
display.
5. To transfer FROM the USB flash drive TO the oven, press the
1 pad.
• Or to transfer programs TO the USB flash drive FROM the
oven, press the 2 pad.
6. Push the START pad to begin transfer.
• Display will read, "Contacting USB card."
• Display will then read, "Transferring data from USB to oven,"
or vice versa
7. Once programming has been successfully transfered, display
will read, "Done - Loaded __ Programs."
• Shut the door to clear the display and begin a cooking cycle.
Part No.20151901
Printed in U.S.A. 05/14
Original Instructions
Quick Start Reference Guide
Refer to Product Safety Manual for Safety Statements

Manual Operation

To cook food using a specific entered time and power level.
1. Open oven door and place food in oven. Close door.
2. Press TIME ENTRY pad and enter cooking time.
3. Press POWER LEVEL pad to change power level if desired.
• For a lower microwave power, press pads 1 (for 10%) through 9 (for
90%)
• Press same number keypad again to change power level to 100%
4. If stage cooking is desired, press STAGE pad and repeat steps 2 through
4.
5. Press START pad.
At end of cooking cycle oven beeps and shuts off. DONE displays.
6.
Preprogrammed Pads
To cook food using preprogrammed cooking sequences.
1. Open oven door and place food in oven. Close door.
2. Press desired pad.
3. Oven begins to cook.
4. At end of cooking cycle oven beeps and shuts off.
CLEAN FILTER
This oven displays CLEAN FILTER at user defined
intervals. When the message displays, ACP recommends
cleaning the air filter thoroughly. Cleaning the air filter
will not shut off the message. The message will stop
displaying automatically after 24 hours. Depending on
microwave use and environmental conditions, the filter
may need to be cleaned more frequently.
F
or full product documentation visit:
www.acpsolutions.com
This guide covers model:
Complete Owner's Manual available online

Oven Clearances

A—For North American (UL/CSA) models, allow at
least 2" (5.1 cm) of clearance around top of oven.
For International (50 Hz) models, allow at least 7"
(17.8 cm) of clearance around top of oven. Proper
air flow around oven cools electrical components.
With restricted air flow, oven may not operate
properly and life of electrical parts is reduced.
B—Allow at least 2
discharge on back of oven and back wall.
C—Allow at least 2" (5.1 cm) around sides of oven.
• To add an additional serving press QUANTITY pad.
• Display will read, "DOUBLE."
DONE displays.
MSO*
/
9
" (6.5 cm) between air
16
 2014 ACP, Inc.
225 49th Avenue Drive
Cedar Rapids, Iowa 52404