Message Display - Sony PCM-M1 Operating Instructions Manual

Message Display

The following messages will be displayed on the main unit while operating this unit.
Message Description
Appears when there is no tape inside the unit.
Flashes when the cassette compartment lid is open.
Flashes while loading a tape.
Flashes when unloading a tape.
Appears when the digital input signal is not received.
and
button is pressed or when writing/erasing a Start ID in the
playback mode using a tape whose record-protect shutter is
open.
Flashes for a moment when you set the HOLD switch to
HOLD on the main unit. Appears or flashes when you press
a button while the HOLD function is operating.
Flashes when the beginning of a tape*
Flashes when the end of the tape is reached.
Appears when the End ID*
Flashes when the unrecorded segment of a tape is detected
during playback or fast-forwarding.
Appears when the r REC button is held down during MIC
recording, recording pause, recording monitor modes.
Appears when the r REC button is held down during
recording pause or recording monitor modes while another
equipment is connected via the analog connection.
Appears when the r REC button is held down in the
recording pause or recording monitor modes while another
equipment is connected via the digital connection.
Appears when the Start IDs are being written.
Flashes when the Start ID is pressed during playback mode
in the rehearsal function.
Flashes when the Start IDs are being erased.
Flashes when the program numbers are being renumbered.
Appears when the AVLS is set to LIMIT, or when the AVLS
is operating and the VOL button is pressed.
Appears when volume is set to the maximum level.
Appears when volume is set to the minimun level.
Flashes when the batteries are weak.
appears alternately when the r REC
1 is reached.
2 is detected.
Additional Information
45 EN