Making A Channel 16/9 Distress Call; Making A Dsc Distress Call - Navico Simrad RS90S User Manual

1.
2.
3.
4.
5.
6.
7.
8.
•
•
26 |

Making a channel 16/9 distress call

If not already on the priority channel, press the [16/9] key.
16 /
9
Listen to make sure there is no traffic on the channel.
Hold down [PTT] and announce your distress call.
Say your call sign, details of your vessel, its position and the nature of
the distress.
Say "over" and then release [PTT] when you have finished speaking.
Allow a short time for a reply.
If you don't hear a reply, repeat the distress call (steps 3 to 6 as
above).
When you receive a reply, continue the conversation:
• Hold down [PTT] while you are speaking.
• Release [PTT] while you are listening.
You may be asked to change to a working channel.
Notes:
In the USA, you can toggle between Channel 16 and Channel 9 as
the priority channel. Hold down [16/9] until a beep sounds and the
required priority channel is displayed.
This feature needs to be setup in the radio settings ("Setting the
priority channel" on page 90).

Making a DSC distress call

Using the DSC system (where available) you can make a distress
call by pressing a single Distress button. For further information, see
"Introduction to DSC" on page 40.
Operating procedures | RS90S User Manual