(1) Connect two E810-DTU serial ports and network cables to PC, open the network configuration software and search for the device. The searched device will
display the device list. Double-click the device to be configured in the list and enter the setting interface. Set the module to UDP Client mode, set the target IP address to
192.168.3.100, set the target port of module A to 8887, the target port of module B to 8886, set the RF parameters, click the OK button after the setting is complete, and then
restart the device to search Check once to see if the parameter modification was successful.
Click Read Parameters on the RF Parameter Settings interface to obtain the module's current RF parameter settings. Then you can configure the RF settings.