Ebyte E810-DTU User Manual page 18

Ethernet to 485/232
TCP Client instructions
6.2.2.
(1) Connect two E810-DTU serial ports and network cables to PC, open the network configuration software and search for the device. The searched device will
display the device list. Double-click the device to be configured in the list and enter the setting interface. Set the module to TCP Client mode, set the target IP address to
192.168.3.100, set the target port of module A to 8887, the target port of module B to 8886, set the RF parameters, click the OK button after the setting is complete, and then
restart the device to search Check once to see if the parameter modification was successful.
Click Read Parameters on the RF Parameter Settings interface to obtain the module's current RF parameter settings. Then you can configure the RF settings.
Copyright ©2012–2017，成都亿佰特电子科技有限公司
Figure 17 Searching devices
Figure 18 Parameter settings
E810-DTU User Manual
17