Wireless modem, four serial ports serial server (38 pages)
Summary of Contents for Ebyte E840-DTU
Page 1
E840-DTU(4G-01) User Manual This manual may change with the continuous improvement of the product. Please refer to the latest version of the instruction. Chengdu Ebyte Electronic Technology Co., Ltd. reserves all rights of final interpretation and modification of this manual.
Page 2
Initial version huaa E840-DTU (4G-01) is a developed for serial devices and network servers to transmit data to each other via network. This product is a LTE-FDD/LTE-TDD/WCDMA/TD-SCDMA /CDMA/GSM wireless communication data transmission station with diversity reception function., supporting LTE-FDD, LTE-TDD, DC-HSDPA, HSPA+, HSDPA, HSUPA, WCDMA, TD-SCDMA, CDMA, EDGE and GPRS network data connections. Through simple AT commands Settings, users can easily use this product to achieve two-way data transparent transmission from serial to network.
1.1. Brief introduction E840-DTU (4G-01) is an LTE digital radio modem product developed by Ebyte. The software is fully functional and covers most common application scenarios. Users can implement two-way data transparent transmission between serial and network server with simple settings. .
Page 11
//read version info. And enter AT command setting at the same time +OK=E840-DTU(4G-01)_V1.0 Transmit:AT+SOCK2=1,TCPC,116.62.42.192,31687 //open SOCK2 and configure the network server parameters that SOCK2 will connect to (the parameter used here is Ebyte test server, not recommended for users) Transmit:AT+LINKSTA2 //read if SOCK2 has started connection with server +OK=Connect Transmit:AT+POTOCOL=ON...
Page 12
The user only needs to set the forwarding relationship of the corresponding device to the platform to implement the device. Data is transparent. For details of the related operations, please refer to the "Ebyte Cloud Platform Transparent Transmission Guide".
Page 14
4G/LTE Serial Server E840-DTU(4G-01)User Manual HEARTM set/inquire heartbeat packet time SHORTM set/inquire short connection time EBTIOT set/inquire to enable Ebyte IoT Cloud Platform CREG Inquire if it is registered to network inquire signal strength CPIN Inquire SIM card status POTOCOL set/inquire if protocol transmission mode starts Command Description:...
Page 19
Format: inquire transmit:AT+ SHORTM<CR> return:<CR><LF>+OK=<time><CR><LF> configure transmit:AT+ SHORTM=<time><CR> return:<CR><LF>+OK<CR><LF> parameter: time short connection time, 0 off,from 2-255 second AT+EBTIOT Function: set /inquire EBYTE IoT Cloud platform Format: inquire transmit:AT+EBTIOT <CR> return:<CR><LF>+OK=<ctrl><CR><LF> configure transmit:AT+EBTIOT =<ctrl><CR> return:<CR><LF>+OK<CR><LF> parameter: ctrl EBYTE IoT function switch,0 off/1 on Note: After the IoT cloud function is enabled, the module is automatically connected to the Yiyi special IoT platform, ignoring the sock configuration, registration package, and heartbeat package function.AT+CSQ...
7. The maximum single packet length supported by a single link in this module is 1024 bytes. A local serial port or a network sending a packet exceeding this length in a single transmission may cause a packet abnormality. 6. Important Statement All rights to interpret and modify this manual belong to Ebyte. ...