Table of Contents
Advertisement
•
The Ultra Low Maxx system is fitted with drive
lockouts. Make sure this is set so as not to
compromise the user's stability while driving.
•
All power bases have programmable controllers which
allow adjustment of the maximum acceleration and
deceleration of the wheelchair. Make sure that these
are set to an appropriate level for the system and
for the user.
•
Ensure all medical conditions are considered when
setting up the wheelchair. Involuntary muscle
movement such as spasming may affect the stability
of the wheelchair, especially when the seating system
is in a tilted or reclined position.
•
When a system is fully tilted or reclined, the front
wheels of the power base should never come off the
ground. If this occurs, you must adapt the system's
center of gravity.
5.3.1 Adjusting center of gravity
To achieve the best overall base stability, the system depth
should always be adjusted as stated in the service manual.
There are two kits available to fit all seat depths:
•
Seat depth kit for seat depths 380 – 480 mm
•
Seat depth kit for seat depths 480 – 580 mm
Tools:
•
2 x 13 mm wrench
CAUTION!
Risk of strains from lifting heavy parts!
– Use proper lifting techniques.
1.
The graphic of the TDX SP2 serves as an
example. TDX SP2 Low-Rider and Storm
handled similarly.
Loosen screws and nuts and remove together with
washers A.
2. Adjust system to desired position.
Depending on the seat depth and the type of power
wheelchair, the system is screwed on in different
positions. See following chapters.
3. Insert screws, nuts and washers and tighten.
1586649-F
5.3.2 Mounting positions for TDX SP2
Depending on the seat depth, the system is mounted in
different positions.
Mounting positions of system for seat depth 380 – 480
mm
A one free hole at the rear of the module
The brackets are shown from above and laid side by side
for a better view.
380 mm seat depth
405 mm seat depth
430 mm seat depth
455 mm seat depth
480 mm seat depth (both
seat frame depth ranges)
Mounting positions of system for seat depth 505 – 580
mm
A two free holes at the rear of the module
The brackets are shown from above and laid side by side
for a better view.
4
are
505 mm seat depth
530 mm seat depth
555 mm seat depth
580 mm seat depth
Settings and Adjustments
A
B
C
D
E
A
31
Advertisement
Table of Contents
