Setting Angle And Height Of Calf Pad; Replace Center Bracket For Manual Center; Mount Footrest; Lnx Legrest - Invacare Motion Concepts Ultra Low Maxx Service Manual Supplement

10.2.9 Setting Angle and Height of Calf Pad

• 3/16 inch Allen key
Fig. 10-14
1. Fold the calf pad forward in order to access the bolt
(1).
2. Loosen the bolt using the Allen key and adjust the calf
pad to the required angle and height.
3. Retighten the bolt.
4. Fold the calf pad back.
10.2.10 Replace Center Bracket for Manual
Center Mount Footrest
K
G
C
B
A
Fig. 10-15
Right footrest is not shown for clarity.
For tightening torques on hardware, refer to
Tightening Torques.
1. Remove the mounting screw A that secures the calf
pad adjuster B of the calf pad assembly C to the
T-nut D inside the channel E of the center bracket F.
2. Set calf pad assembly aside for re-installation.
Calf pad assembly C does not need to be
disassembled.
3. Remove the T-nut out of the channel of the center
bracket.
4. Repeat steps 1–3 for remaining calf pad assembly.
5. Remove the mounting screw G, spacers H, washers
I and locknut J that secures the center bracket to
the footrest support K.
6. Secure the center bracket to the footrest support K
with mounting screw G, spacers H, washers I and
locknut J.
7. Insert the T-nut into the channel on the center bracket.
8. Secure the calf pad adjuster of the calf pad assembly
to the T-nut with a mounting screw A.
9. Repeat steps 6–8 for remaining calf pad.
1586649-F
J
I
H
F
E
D

10.3 LNX legrest

10.3.1 Removing/installing crossbrace of
side-mounted legrests
Tools:
• 13 mm wrench
Removing
1. Loosen screws A on both sides.
Make sure to loosen the screws so far that they do
not collide with the slot hole in the side rail.
2. Pull crossbrace out of side rails.
Installing
1. Insert crossbrace into side rails.
2. Align crossbrace with sliding block.
3. Tighten screws.
10.3.2 Replacing LNX powered center-mounted
legrest with telescoping footboard
Replacing the complete legrest must be done by Invacare.
There are several settings to observe to ensure correct
functioning. Contact Invacare for details.
Replacing legrest actuator
Tools:
• 6 mm Allen key
• 8 mm Allen key
• 16 mm wrench
1. Switch off power wheelchair.
2. Unplug actuator from actuator module.
3. Remove screws and nuts at top A and bottom B of
actuator.

Legrests

67