The lift is easy to operate using operating panels mounted on the wall, on the lift, or by means of a remote control. Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
Reseller for the Product, provided that Reseller returns the Product to Liftup in accordance with Liftup’s standard return material authorization procedures or as otherwise instructed by Liftup. Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
Page 6
OF AN IMPLIED WARRANTY, SO CERTAIN OF THE ABOVE LIMITATIONS MAY NOT APPLY TO EVERY RESELLER. Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
Page 7
Changes and modifications not expressly approved by the manufacturer or registrant of this equipment can void your authority to operate this equipment under Federal Communications Commission rules. Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
FlexStep V2 are in compliance – consult your reseller for further information. Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
IMPORTANT! The owner of this FlexStep V2 is obliged to maintain it according to the Maintenance Guide in section 12. Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
30 cycles at 25 ˚C / 77 ˚F - Fully charged = 5 hours Flat battery: 10 min. charge = 1 trip Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
Page 13
Storage temperature: -25ºC to +70ºC / 13ºF to 158ºF Expected service life: > 5 years Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
Page 14
-25ºC to +70ºC / 13ºF to 158ºF Expected service life: > 5 years Right reserved to make technical modifications Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
(please see section 10.8). In such cases, run the lift down in order to exit it. *Has completed a Liftup product and service course Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
If the lift is fitted with a safety barrier (supplementary equipment) at the top level, it will close before the lift begins to move. Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
In order to operate the FlexStep V2 as a wheelchair lift when you are on the platform, use the operating panel fitted to the stair handrails. Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
This button is used to disconnect the power supply to the lift. If the user Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
Ding Ding Ding Arriving at top/bottom level Ding Ding Ding The lift has become a staircase Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
Page 24
High tone followed a deeper tone Low tone followed by higher tone Identical tones (3 off) Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
2. Remove the back panel 3. Swap the battery 4. Refit the back panel and test Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
Page 27
PCB with the battery is mounted 2. Swap the battery 3. Refit the parts and test Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
Should the control LED not flash rapidly, this means that no receiver has been paired. Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
Should the control LED not flash rapidly, this means that no receiver has been paired. Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
USER MANUAL – FLEXSTEP V2 – US VERSION 1.3 14. Installation and handover form The form below shall be filled out upon installation. Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
NB. It is not enough to disconnect the power supply, as the system is fitted with a battery backup. Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
Page 32
A check form like the one below shall be filled out at each inspection. The form shall be filed by the company which has entered into the service agreement. Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
The service logbook form shall be filled out after each inspection. The logbook shall be kept together with the lift. Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
Enjoy using your new FlexStep V2! Best regards, Liftup Inc. Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
Page 36
USER MANUAL – FLEXSTEP V2 – US VERSION 1.3 Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us...
Need help?
Do you have a question about the FlexStep V2 and is the answer not in the manual?
Questions and answers