Switching The Uroshield; On Or Off - NanoVibronix UROSHIELD User Manual

UroShield® User Manual
The UroShield® is now charging and is ready to be switched on (you do not
need to wait for the battery to charge fully, which takes about 2 hours).
6.2

Switching the UroShield

ON or OFF

®
To switch the UroShield® ON or OFF, press the ON/OFF button for 2–3 seconds.
About 30 seconds after you switch the UroShield® ON, the driver display shows
the status of the battery and actuator connection as shown in the following
screen:
If another screen appears instead of the above, see section 6.4.2 Alarms and
Troubleshooting.
After another 3 minutes, the display dims and shows the screensaver:
UroShield
Note: when the screensaver is shown, you can return to the battery/actuator
status and brighten the screen by pressing the ON/OFF button briefly (that is,
for less than 2 seconds).
USUM005 Ver. 07 17