Dampers Hoods; Stop-Drop - Carrier 50EN 415 Installation, Operation And Maintenance Instructions

12 - FACTORY OPTIONS AND ACCESSORIES

12.4 Dampers hoods

The fresh air and exhaust air damper hoods (depending on the
assembly chosen) are supplied disassembled. The installer have
to assemble them on site, and then, attach them to the unit.
The three parts that make up the visor (1), (2) and (3) are joined
by self-tapping screws (supplied with the unit).
The upper grip of the hood must be inserted below the panel of
the upper box or the lid in order to prevent water from entering.
Each hood is attached to the unit with Allen M4 screws (supplied
with the unit).
2
2
24

12.5 Stop-drop

The stop-drop can be installed in the indoor air coil and on the
fresh air intake.
● Indoor air coil (available
1
● Fresh air intake: the frames with the stop-drop have to be
3
1
3
for models 415 to 960 and
included in models 1100
and 1200): recommended
in cases where a high
moisture content in the air
is foreseen or when the air
fl ow is high.
Note: The stop-drop in
the indoor air coil is not
compatible with the hot
water coil.
This optional is easily
removable from the side of
the unit.
Stop-drop in
the indoor coil
placed after the hood (both supplied separated from the unit).
The frames must be inserted behind the top fl ap of the hood,
and then, they must be dropped over the rail.
Rail Top fl ap