Note For Printed Wiring Board And Schematic Diagrams - Sony Net MD Walkman MZ-N1 Service Manual

6-4.

NOTE FOR PRINTED WIRING BOARD AND SCHEMATIC DIAGRAMS

Note on Printed Wiring Board:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from
(Conductor Side) the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(Component Side) the parts face are indicated.
• MAIN board is four-layer printed board.
However, the patterns of layers 2 and 3 have not been
included in this diagrams.
• Lead Layouts surface
Lead layout of conventional IC CSP (chip size package)
Note on Schematic Diagram:
• All capacitors are in F unless otherwise noted. pF: F
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in and 1 / W or less unless otherwise
4
specified.
• % : indicates tolerance.
• C : panel designation.
Note:
Note:
Les composants identifiés par
The components identi-
fied by mark 0 or dotted une marque 0 sont critiques
line with mark 0 are criti-
pour la sécurité.
cal for safety. Ne les remplacer que par une
Replace only with part pièce por tant le numéro
number specified. spécifié.
• A : B+ Line.
• Total current is measured with MD installed.
• Power voltage is dc 3 V and fed with regulated dc power
supply from DC IN 3 V jack (J601).
• Voltages and waveforms are dc with respect to ground in
playback mode.
no mark : PLAYBACK
( ) : REC
: USB
: Impossible to measure
• Voltages are taken with a VOM (Input impedance 10 M ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
E
: PLAYBACK
j
: REC (ANALOG IN)
l : REC (DIGITAL IN)
F : USB CHECK OUT
• The voltage and waveform of CSP (chip size package)
cannot be measured, because its lead layout is different
form that of conventional IC.
33 33
MZ-N1