Advertisement
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-2. DC motor, Controller, Switch unit (cont.)
ASSEMBLING
(4) Insert Motor rubber ring A between Motor housing set and DC motor, then pass Flat washer 10 through Spindle.(Fig. 8)
Note: Push down Motor rubber ring A so that Spindle top can protrude from Ball bearing 6000DDW as illustrated in Fig. 8.
Fig. 8
Motor rubber ring A with Ball bearing 6000DDW
Aligning these protrusions to
the ribs of Motor housing set,
put Motor rubber ring A on
DC Motor in Motor housing set.
(5) Set Grounding terminal in place. Refer to Fig. 9.
Note: Regarding the opposite Grounding terminal of Lead wire (transparent), Refer to Fig. D-4.
Fig. 9
As the stepped portion of Motor drum interferes in insertion of
Grounding terminal, bend the grounding terminal in advance.
Lead wire
(transparent)
Motor
drum
(6) Take the disassembling step in reverse to reassemble the removed parts.
Motor rubber ring A is set in place by assembling Motor housing set.
Rib
Grounding terminal
Motor rubber
ring A
Grounding terminal
Motor rubber ring A
Spindle top protruded from
Ball bearing 6000DDW
Flat washer 10
Note: Do not fit Motor rubber ring A to
Motor housing set completely
in this step.
Insert Grounding terminal deep into the gap
between Motor rubber ring A and DC Motor.
Grounding terminal
Motor
Motor rubber ring A
drum
Make sure that Grounding terminal
is set in place as illustrated below.
Motor
drum
P 5/ 7
Grounding Terminal
less than 3mm
Motor rubber ring A
Advertisement
