Abnormal Cutting Is Performed; The Origin Is Misaligned - Roland monoFab SRM-20 User Manual

Abnormal Cutting is Performed

Is a Large Amount of Cutting Waste Present?
Clean away any cutting waste . Clean the area around the spindle head
especially carefully .
""Cleaning the X-/Z-Shafts"
Is the Location of the Origin Set Correctly?
Check whether the origin has been set correctly . An incorrect origin location
may result in cutting at an unintended position .
"Origin point of the Model / Origin point"
"SRP Player :
"Origin point of the Model / Origin point"
"MODELA Player 4 :
""STEP 2 : Set the Origin Point"
Is the Command Set Correct?
Make sure the appropriate command set for the program you're using has
been selected . An incorrect command mode may lead to errors, unintended
operation, or no operation .
""Setup Dialog" (p . 15)
""STEP 3 : Confirm the Command Set"
(p . 119)
(p . 96)
(p . 89)
(p . 83)

The Origin is Misaligned

Is the Correct Workpiece Coordinate System Selected?
In the NC program, there are six coordinate systems . Depending on which
coordinate system is used, the position of the origin differs . For instance,
if the NC program uses G55, the origins must be set relative to workpiece
coordinate system G55 .
"SRP Player :
"MODELA Player 4 :
""STEP 2 : Set the Origin Point"
" Separate volume
(p . 54)
Has the EXOFS Setting been Made?
The EXOFS in the NC code have a function to shift the origin . Set EXOFS to
zero, then redo the settings for the origins . If the origin is still shifted, check
the program .
How to set EXOFS to zero
1.
[Machine Coordinate System]
Select
coordinate system on the VPanel.
2.
Move the tool position to
3.
[EXOFS]
Select
4.
Click [X/Y]
129
"Origin point of the Model / Origin point"
"Origin point of the Model / Origin point"
(p . 89)
"NC Code Reference Manual"
from the display of the
"X: 0", "Y: 0", "Z: 0."
[Set Origin Point].
at the
and [Z] at the [Set Origin Point].
What to Do If . . .
(p . 96)
(p . 54)