Operations Are Ignored - Roland monoFab SRM-20 User Manual

Operations Are Ignored

Is the Cable Connected?
Check whether the connector cable has come loose . Please use the included
cable .
Was the Machine Started According to the Correct Procedure?
Before you start VPanel, switch on the power to the machine .
""Start VPanel"
(p . 11)
Is a Front Cover Open?
This machine restricts some operations when a front cover is open . Close
the front cover .
Is a Front Guard Pull Down ?
When the front guard falls down, the front cover can not be closed firmly .
Therefore the machine is not performed .
"Part Names and Functions"
"
Is Anything Caught on the Spindle Head or Rotary Axis Unit?
Check whether something has become caught and is impeding initialization .
(p . 9)
Is a Large Amount of Cutting Waste Present?
Clean away any cutting waste . Clean the area around the spindle head
especially carefully .
""Cleaning after Cutting Operation Ends"
Is Operation Paused?
When the machine is paused, cutting stops and some operations are
restricted . When you press the
canceled .
""Pausing / Resuming"
Is the Driver Installed Correctly?
If the connection to the computer is not made in the sequence described,
the driver may fail to be installed correctly . VPanel does not function
normally when driver is misconfigured . Check again to ensure that the
connection was made using the correct procedure .
"http://startup.rolanddg.com"
"Download
""The Driver Cannot Be Installed"
Is VPanel Displaying an Error Message?
""Responding to Error Messages"
127
(p . 119)
"RESUME"
button of VPanel, the pause is
(p . 104)
(p . 131)
(p . 144)
What to Do If . . .