Installation Steps; Default Steering Wheel Control Programming; Default Swc Button Assignments - PAC RP5-GM11 Manual

RP5-GM11

Installation Steps

SET RADIO SELECT SWITCH
Alpine
1
*Other - Dual / Axxera, Jensen, Rockford Fosgate
1. The radio select rotary switch on the side of the interface must be adjusted to the proper radio
setting before plugging the interface into the vehicle.
2. Make all connections as described in the chart on page 1. Be sure to connect both Yellow wires (one from vehicle harness
and one from RP5 harness) and both Black wires (one from vehicle harness and one from RP5 harness) while making these
connections.
3.
4. If the aftermarket radio is equipped with an auxiliary input and you wish to retain the factory RSE audio, plug the RCA
connectors from the secondary harness into the radios auxiliary input.
5. With the ignition off and the driver door opened: Connect the interface to the vehicle's harness(es). Connecting the
interface with the ignition on can cause erratic behavior. Please make sure the ignition is off and the driver door is opened
when performing this step.
6. Plug the CMX chime module in if necessary (If the vehicle chimes when the radio is removed the CMX is not necessary).
PLEASE NOTE: In order to get the best possible sound out of the CMX, please mount it in a place free and clear of any
7. The Mute loop (if not cut) will turn the accessory output off when an OnStar or Bluetooth call is made or received. If the
aftermarket radio has a mute input, cut this loop and connect the outer brown wire to the mute input.
8. Connect the SWC wire according to the chart on page 1 (aftermarket radio MUST support a wired remote input).
9. If you wish to reassign functions to the SWC follow the programming instructions on the next page.

Default Steering Wheel Control Programming

IMPORTANT! The interface comes pre-programmed for the functions listed in the chart below and does not require programming
unless you wish to re-assign the SWC functions to different buttons. The SWC can always be restored to default settings by

Default SWC Button Assignments

Volume +
Volume -
Source Up
Source Down
Seek Up
Seek Down
Voice
Prog
Default SWC Button Assignments (Corvette)
Volume +
Volume -
Seek Up
Seek Down
Voice
End
P ifi A C ti
Kenwood /
JVC
Lightning Audio
2 3
Alpine JVC
Volume + Volume +
Volume - Volume -
Source Source
Band Preset +
Track + Track +
Track - Track -
Voice Voice
Preset Up Preset -
Alpine JVC
© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
Radio Replacement & Steering Wheel Control Interface
with OnStar Retention for General Motors Vehicles
Clarion / Pioneer /
Nakamichi Other*
4 7
Kenwood Clarion
Volume + Volume +
Volume - Volume -
Disc/FM+ Source
Disc/AM N/P
Track + Search +
Track - Search -
Voice Voice
Source Band
Kenwood Clarion
PAC-audio.com
Sony Fusion
8 9
Sony / Pioneer Fusion
Volume + Volume +
Volume - Volume -
Source Source
Band Off
Track + Track +
Track - Track -
Voice Mute
Preset + Audio
Sony / Pioneer Fusion
Rev: 5
Date: 050918
Page 2