Rear Seat Entertainment (Rse); Onstar Volume Adjustment For Vehicles W/O Swc - PAC RP5-GM11 Manual

RP5-GM11
7. The LED and radio will turn off when RAP turns off or the drivers door is opened.
8. Use the 4-position selector switch located on the side of the CMX module to select the best chime output volume for your
Rear Seat Entertainment (RSE); If equipped
The factory RSE system will function independently from the aftermarket radio. The unit will power up and pass audio through
the headphones as long as the vehicle's ignition is on. If you wish to pass audio from the RSE to the aftermarket radio you must
connect the RCAs from the 12-pin connector to the aftermarket radios auxiliary input. Select the aftermarket radios auxiliary input
to hear RSE audio.

OnStar Volume Adjustment for Vehicles w/o SWC

1. If SWC buttons are not present you must use the
programming button on the interface to control the OnStar
audio level during an OnStar connection.
2. When OnStar is active pressing the programming button
will raise the audio level 8 times before returning to the
original level. Every time the button is pressed a
Technical Support and Product Updates (Firmware)
Technical Support
support@PAC-audio.com
866-931-8021
P ifi A C ti
CMX
chime module
© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Radio Replacement & Steering Wheel Control Interface
with OnStar Retention for General Motors Vehicles
2
1
x3
Press the programming button
on the side of the interface while
OnStar is active to adjust the
OnStar volume
Rev: 5
Page 4
Date: 050918