Water Filter - DeLonghi MAGNIFICA S Get Started

WATER FILTER

Installing the filter
1. Remove the filter from the
packaging.
2. Turn the date indicator disk
(A) until the next 2 months of
use are displayed.
3. To activate the filter, put it
under tap water until water
overflows the side openings
for more than 1 minute (min.
500 ml) (B).
4. Remove the tank from the
appliance and fill with water.
5. Insert the filter in the water
tank and immerse it completely
for ten or so seconds, sloping
it to enable the air bubbles to
escape (C).
6. Insert the filter in the filter housing (D)
and press as far as it will go.
7. Close the tank with the lid (E), then place
the tank in the machine. When you install
the filter, you must notify the appliance of
its presence.
A B
Please note! The filter lasts about two months if the appliance is used normally. If the coffee maker is
left unused with the filter installed, it will last a maximum of three weeks.
8. Press the P button to enter the
menu.
9. Press
flashes
10. Turn the dial until the
11. Press
selection.
12. Turn the steam knob counter-
clockwise and press the
13. At the end of delivery, the
flashes. Turn knob clockwise and
the machine is ready for coffee.
Please note:
It may happen that a single hot water
is not sufficient to install the filter:
the lights come on.
In this case, repeat the installing operation
from step 8. The new filter is active and
you can now use the coffee maker.
C D
button : the OK led
and
lights come on.
button to confirm the
button.
E
light