Lighting The Pilot - Hargrove Hidden Control Series Installation And Operation Manual

Vented gas logs

Hide thumbs

Table Of Contents

Table of Contents

Read the lighting instruction plate

attached to the gas valve or located at

the end of these instructions.

Push in gas control knob slightly and turn

clockwise until the knob will not turn any

longer. This is the "OFF" position. The

word off should be at the 12 o'clock

position on the control knob.

Slightly push in on pilot knob and turn

valve to the "PILOT" position. Push the

knob in all the way and hold in.

Immediately light the pilot. (The pilot is

located on the right side of the burner

pan) Continue to hold the knob for at

least 30 seconds after the pilot is lit.

Release the knob and the pilot should

remain lit.

Turn the burner to the "ON", the pilot

flame should ignite the main burner within

4 seconds.

Carefully check the connections for

leaks using a soapy solution.

NOTE- if the pilot will not stay lit after

several tries turn the control off and

call a technician.

Fill the burner pan with sand for Natural

gas. For LP no media is needed, just fill

the burner with Glowing Embers. The

media level should be sloped evenly with

the sides of the burner pan. Under filling

will cause uneven flame.

Glowing Embers (Rockwool) are placed

over the media. For best results pinch off

pieces of the rockwool the size of a dime

and feather it out

Test fire the burner once again for

flame distribution, media can be

altered to achieve desired flame

appearance.