Pre-Installation Checklist; Damper Stop Installation - Hargrove Hidden Control Series Installation And Operation Manual

FIREPLACE AND CHIMNEY
 Fireplace is approved for solid-fuel burning and made of non-combustible materials.
 Operational damper with a chimney free of any obstruction or restriction.
 Fireplace has proper draft to accommodate decorative appliance.
 Fireplace is free from debris or ash.
 Fireplace is free of obstruction such as log grate, log lighter, etc.; that would prohibit
the installation of the log set.
 If the floor is recessed or glass doors are installed on the fireplace, the appliance may
need to be elevated to ensure proper air flow.
 Consult table to determine if the set is properly sized for the installation in the fireplace.
GAS LINE
 Ensure gas line is in safe condition and that it is adequate for the installation.
 Check gas line sizing to ensure it is properly sized for the appliance.
 For ease of installation gas line should be located on the right side of the fireplace
when possible.
 Turn the gas supply line off and you are ready to begin burner installation.
Attach the damper stop clamp to the fireplace damper blade. Position the clamp to prevent full closure
of the fireplace damper blade.
If the damper stop provided does not fit, the installer shall install a permanent damper stop that will keep
the damper open to a minimum opening as determined on page 3 Table II of the instructions.
CAUTION
THE DAMPER MUST BE FULLY OPEN WHEN
OPERATING THE GAS LOGS!
IMPORTANT: In the Commonwealth of Massachusetts the damper must be
either permanently welded in the fully open position or completely removed.

PRE-INSTALLATION CHECKLIST

DAMPER STOP INSTALLATION

Masonry Fireplace
Prefab Fireplace
4