H3C S3100-52P Operation Manual page 7

Operation Manual – SSH Terminal Service
H3C S3100-52P Ethernet Switch
Note:
After the rsa local-key-pair create command is executed, you can execute the
display rsa local-key-pair public command to display information about the public
key (in H3C_host, for example).
III. Configuring authentication type for a user
For a new user, you must specify the authentication type. Otherwise, the user cannot
access the switch.
Table 1-4 Configure authentication type for a user
Enter system view
Specify
authentication
SSH users
Configure authentication
type for an SSH user
Note that:
The ssh authentication-type default command is used to configure the default
authentication type for all SSH users.
The ssh user username authentication-type command is used to configure an
authentication type for a specific SSH user.
When both commands are configured with different authentication types, for the
specific user (user specified by the username argument), the authentication type
specified by the ssh user username authentication-type command will take
effect instead of that specified for all SSH users.
Operation
system-view
ssh authentication-type
a default
default { password | rsa
type for
| password-publickey |
all }
ssh
authentication-type
{
password-publickey
rsa| all }
Chapter 1 SSH Terminal Service
Command
user username
password |
|
1-6
Description
—
At least one required;
By default,
authentication type
specified for an SSH user,
and the user can not
access the switch.
no
is