The P2 mode can be accessed in the service mode, depending on adjustment and/or
confirmation need. Check parameters according gas and model type and check results
according to the manual – ensure constant result (P
Minimum Power
adjustment
(Minimum gas and water flow)
Remote control registration
Page 41 from 76
Technician Level
Minimum power burner
adjustment after repairs /
maintenance / gas
conversions
When P2 is visible, press "P" and enter in the 2
for enter and/or exit P1
Minimum Input Power
Adjustment of air flow without
change gas conditions
Adjustment of gas flow
without change air conditions
Table 26 – P2 sub menus
Installer Level
Table 27 – P3
6 720 814 719 SM FP_Australia 2017/04 EN
– P
= P
– P
burner
box
L2
A2
Comments
P2 contains the fan speed setting (A2)
and gas power (L2) at minimum power
(depends on gas type / model)
(depends on gas type / model)
nd
level accessing "E"
Not Used (by default will display 20)
Range from 0 to 40
Spare part default setting is 20
Range from 0 to 40
Spare part default setting is 20
Technician Level
)
Comments
Not used