Mounting/Disassembly - Siemens LOGO!Power Series Operating Instructions Manual

Mounting/disassembly

Installing the device in a housing or a control cabinet
The LOGO!Power power supplies are built-in units. They must be installed in a casing or
control cabinet to which only qualified personnel have access.
The devices can be mounted in a control cabinet on standard mounting rails according to
EN 60715 35x7,5/15.
Mounting
To mount the device, position it with the mounting rail guideway at the upper edge of the DIN
rail and press down to lock it into place. If this is too difficult, press slider
time, as described for "Disassembly".
Disassembly
To remove, pull up the slider
bottom edge of the DIN rail. Then you can remove the device from the upper edge of the DIN
rail.
Figure 3-1
LOGO!Power
Operating Instructions, 06.2014, C98130-A7560-A999-3-7629
WARNING
Disassembly (example of 6EP1311-1SH13)
①
using a screwdriver
①
②
and disengage the device at the
3
at the same
17