Operation - Kettler 0193321-2100 Assembly Instructions Manual

Operation

Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor
area. Connect the propane gas tank to the regulator and turn the valve on the unit to the "off"
position. Brush a soap and water mixture on all connections. Turn the gas supply on; if bubbles
occur on any connection there may be a leak. If you smell gas or a leak is discovered turn the
gas valve off, disconnect propane gas tank and do not use the appliance until the leak
is repaired.
Do not use the heating unit without inspecting the gas hose. If there are signs of wear or
abrasion you must replace the hose (if applicable). Pumice stones/lava rocks/Lava Glass® could
pop up and strike somebody's face during the process of lighting this unit; stand away from the
unit for the first 20 minutes after igniting. Flame height should be a yellow/blue color between
2-10 inches in height.
Wait 5 minutes after extinguishing flame prior to placing the lid (if applicable) or protective cover
on heating item.
To Light
1. Make sure the control knob (K) is in the
"OFF" position.
2. Open the door (E) and slowly open the
valve on the propane gas tank by turning
the knob counterclockwise.
3. Close the door (E) on the body.
4. Push and hold in the electronic igniter
(L) to create sparks within the electrode,
continue to hold.
5. Push in the control knob (K) and turn to
the "LOW " position. Keep holding down
the control knob (K) to allow gas to fow for
45 seconds.
6. If ignition doesn't occur within a few
seconds release the control knob (K) and
rotate to the "OFF" position. Wait for 5
minutes for gas to clear and then repeat
the above lighting instructions.
7. Once the fre product is lit, the fame
intensity may be controlled by turning the
control knob (K) between the "LOW and
"HIGH" positions.
To Extinguish
1. Turn control knob (K) clockwise to the
"LOW " position; let the knob pop up and
continue turning the control knob (K) to
the "OFF" position.
2. Close the cylinder valve on the propane
gas tank if you don't intend to use it for a
long time.