Disassembly Instructions - Mitsubishi Electric MSZ-HM09NA-U1 Service Manual

10

DISASSEMBLY INSTRUCTIONS

<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are 2 types (refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
10-1. MSZ-HM09NA MSZ-HM12NA MSZ-HM15NA
OPERATING PROCEDURE
1. Removing the panel
(1) Remove the horizontal vanes.
(2) Remove the screw caps of the panel. Remove the
screws of the panel.
(3) Unhook the lower part ( ) of the panel.
(4) Hold the lower part of both ends of the panel and pull
it slightly toward you, and then remove the panel by
pushing it upward.
OBH746B
(2) The terminal with this connector has the
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Photo 1
30
locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
NOTE: Turn OFF the power supply before disassembly.
PHOTOS
Horizontal vanes
A
Screws of the panel
Front panel