Wire Cord Connections - Haier HLF103Q Service Manual

Danger :
Improper connection of the equipment grounding conductor can result in a risk of electrical shock. Check with a
licensed electrician if you are in doubt as to whether the appliance is properly grounded. The dryer MUST be connected
to a grounded metal, permanent wiring system, or an equipment grounding conductor must be run with the circuit conductors
and connected to the equipment-grounding terminal or lead on the appliance.
C
3

3-wire cord connections

1. Remove the screws securing the terminal block access cover
and the strain relief mounting bracket located on the back of the
dryer in the upper corner.
2. Install a strain relief into the power cord entry hole of the
mounting bracket. Finger tighten the nut only at this time.
3. Thread a 30 Amp. Power cord, 245 IEC66(YCW) 450V/750V ,
through the strain relief.
4. Attach the power cable earthconductor to the silver
coloured centre terminal on the terminal block. Tighten
the screw securely.
5. Attach the remaining two power cable outer conductors to the
outer silver coloured terminals on the terminal block. Tighten both
screws securely. Warning:Do not make a sharp bend or crimp
wiring/conductor at connections.
6. Reattach the strain relief mounting bracket to the back of the dryer
with two screws. Tighten screws securely.
7. Tighten the screws securing the cable restraint firmly against the
power cable.
8. Tighten the tension relief nut securely so that the tension relief
does not turn.
9. Reinstall the terminal block cover.
This appliances must be connected to a ground metal,permanent wiring system, or an equipment-grounding
Grounding
instruction:
conductor must be run with the circuit conductors and connected to the equipment-grounding terminal or
lead on the appliance.
Warning:
Improper connection of the equipment-grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or service representative or personnel if you are in doubt as to
whether the appliance is properly grounded.
Caution: Label all wires prior to disconnection, when servicing controls.Wiring errors can cause improper operation
and be dangerous. Check unit for proper operation after servicing.
Discard or destroy the carton and plastic bags after the dryer is unpacked. Children should not be allowed to use
Warning:
them to play with. Cartons covered with rugs bedspreads, or plastic sheets can become an airtight chamber
and cause suffocation leading to death. Make all packing materials inaccessible to children.
Warning:
The instructions in this manual and all other literature included with this dryer can not cover every possible
condition and situation that may occur. Good safety practice and caution must be applied
when installing, operating and maintaining any appliances. After installing, if you are indoubt,
call a qualified electrician to install and wire the dryer.
8
brass terminal
L
strain relief
mounting bracket
N
tighten nut
nut
to these threads
power cord