Antenna Port 2 - Cisco Aironet 1520 Series Hardware Installation Manual

Chapter 1 Overview
Connectors
The optional features of the access point support these connectors (see
•
•
•
•
•
•
•
Antenna Connector Locations
The access point is manufactured in three configurations, cable, mesh, and pole mount. These
configurations support specific locations for the access point antennas, as shown in
Table 1-1
Antenna
Port
1
2
3
4
5
6
1. Reserved for future use. A plug is installed.
OL-12632-02
PoE-in connector—internal RJ-45 with liquid tight adapter for waterproofing
PoE-out connector—internal RJ-45 with liquid tight adapter for waterproofing
Three or four antenna connectors (Type N)—depends on access point configuration
Fiber-optic connector—internal small form-factor pluggable (SFP) transceiver with LC connector
Power-over-cable (POC) stinger connector—customer provided
AC power connector (3-pin Remke Mini-Link 50908)
DC power connector—internal 2-pin connector
Antenna Locations per Access Point Configuration
Access Point Configurations
Cable
2.4-GHz antenna connector (RX)
5-GHz antenna connector (TX/RX)
2.4-GHz antenna connector
(TX/RX)
1
–
1
–
1
–
Cisco Aironet 1520 Series Outdoor Mesh Access Point Hardware Installation Guide
Figure
Mesh and Pole Mount
5-GHz antenna connector (TX/RX)
1
–
2.4-GHz antenna connector (RX)
2.4-GHz antenna connector (RX)
1
–
2.4-GHz antenna connector
(TX/RX)
Hardware Features
1-1):
Table 1-1.
1-5