Cisco Aironet 1520 Series Hardware Installation Manual page 66

Powering the Access Point
Figure 2-30
1 Liquid tight adapter
2
Ethernet port opening in access point case
Step 8 Slide the liquid tight adapter towards the access point, and screw the threaded end of the adapter into the
access point, and hand-tighten.
Step 9 Use an adjustable wrench, a 22 mm socket, or a Sealcon S-2200-WR wrench to tighten the threaded end
of the adapter to 6 to 7 ft lbs (8.1 to 9.5 Nm).
Step 10 Use an adjustable wrench and tighten the round end of the adapter to 2.7 to 3.2 ft lbs (3.66 to 4.34 Nm).
Step 11 Ensure that the antennas are connected to the access point before you apply power to the access point.
Step 12 Route your Ethernet cable, and cut off any excess cable.
Step 13 Install an RJ-45 connector on the unterminated cable end, and insert it into the power injector. For typical
installation components see
Step 14 Turn on power to the power injector.
Cisco Aironet 1520 Series Outdoor Mesh Access Point Hardware Installation Guide
2-50
Inserting RJ-45 Connector into the Ethernet Port Opening in Case
Figure 2-2.
Chapter 2
3 RJ-45 connector
4
Shielded outdoor-rated Ethernet (CAT5e or
better) cable
Mounting Instructions
OL-12632-02