Communications Options; Web Browser; Telnet; Snmp - Dataprobe iPIO-8 Manual

The iPIO units have a number of means of communication.
Factory Defaults:
IP Address 192.168.1.254
User Credentials
Two user types are supported Administrator and User. The chart below details the available functions of
each type.
User Type
Administrator
General User
5.1.

Web Browser

Point your browser to the IP address of the iPIO unit and enter the credentials as set. The web pages
provide status information on the inputs and outputs of the iPIO, as well as provide configuration for the unit.
Open a browser to the default or current IP address of the unit. Enter the default username and password.
See Sections 6-8 for complete web browser details
5.2.

Telnet

The system supports the Telnet communications protocol for basic setup only.
Connect via Telnet client to the IP address of the iPIO. Enter the credentials as set.
Hello... connected to iPIO-X!
Connected to Telnet Session 1
User> admin
Password> *****
Telnet Factory Default
Port 23
See Section 9 for Telnet and CLI details
5.3.

SNMP

The iPIO is SNMP manageable. Up to four SNMP managers can be defined for the purpose of delivering
status Inform messages.
iPIO-2816_v180808n

5. Communications Options

Default Username / Password
admin / admin
user / user
iPIO-2, iPIO-8, iPIO-16 Users Guide
Access
View, Control and Setup
View and Control
Page 11