Setting Option Setup Method - Samsung AC052MNMSEH Service Manual

4-4 Setting Option Setup Method

Setting Option Setup Method
■
In order to set the indoor unit option code use the wired remote controller and follow the directions below.
Main Menu Sub-menu
1) Press the and
displayed.
2) Press the /
3) Press the /
screen.
• The first digit represents the page number and the remaining five digits are option codes.
• The option code which is currently setting will flicker.
NOTE
/
4) Press the
5) Press the button to save and complete the option setting.
6) Press the button to exit to normal mode.
• Press the
NOTE
• Option code will not be applied if you don't press the
• Setting indoor unit option code is only possible in Master wired remote controller.
You can only check the indoor unit option code in Slave wired remote controller.
• Setting indoor unit option code is possible when one indoor unit is connected. If more than 2
indoor units are connected, you can only check the Master indoor unit option code.
Samsung Electronics
Data bit
1 2 3 4 5 6
buttons at the same time for more than 3 seconds and then a Main menu will be
button to select and then press
button to select and then press
button to set the option code in order. Press
button anytime during setup to exit without setting.
Page number Option Code
1 2 3 4 5 6
SEG1 SEG2 SEG3
0
✴ ✴
Page number
SEG7 SEG8 SEG9
1
✴ ✴
Page number
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2
✴ ✴
Page number
SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
3
✴ ✴
Page number
button to enter a Sub-menu setting screen.
button to enter a Indoor unit option code setting
button to go to the next page.
SEG4 SEG5 SEG6
✴ ✴ ✴
SEG10 SEG11 SEG12
✴ ✴ ✴
✴ ✴ ✴
✴ ✴ ✴
4-33